Candela GMAX / Lase PRO Fault 14.2

1064 nm Simmer Fault

*YAG Simmer circuit fault.

Calibrate laser system.

If problem persists, contact Candela Service.

*Replace HVPS, flashlamps

⚠️ If this information is not enough or you are still facing the same problem, do not hesitate to leave your inquiry in a comment .

4 comments

Comments (4)

Jun 30

I'm facing this error and it's not able to calibrate always giving simmer out 14.2

Do I need to replace HVPS ?

Jun 30

Replying to

I checked the lamp it's not broken but it's not good and old

I will replace it anyway to check

THEPHOTONX